How to Use the EXTRACT-R AR-15 Tool for Quick Disassembly

Quick Answer

Use the EXTRACT-R AR-15 tool to quickly pry out stuck cases or jammed rounds without damaging your chamber, then follow the steps below for fast disassembly and cleaning.

Step-by-Step: Quick Disassembly with the EXTRACT-R

1. 1. Verify the Weapon Is Clear: Remove the magazine, lock the bolt to the rear, and visually confirm the chamber is empty. Place the rifle on safe if the design allows. Common mistake: skipping this step can cause an accidental discharge when you apply leverage. Always double-check the chamber even if you just cleared it.
2. 2. Insert the EXTRACT-R into the Chamber: With the bolt locked back, insert the tool's tip into the chamber so it engages the rim of the stuck case or the edge of a jammed round. Rock the tool gently to seat it under the case head. Common mistake: forcing the tool straight in can bend the rim; use a slight angle.
3. 3. Apply Steady Leverage to Extract the Case: Pivot the handle of the EXTRACT-R downward, using the barrel extension or upper receiver as a fulcrum. The case should slide out with even pressure. Common mistake: jerking or twisting the tool can snap the case rim, leaving a harder-to-remove base. If the case does not move, stop and re-seat the tool rather than increasing force.
4. 4. Remove the Bolt Carrier Group (BCG): Once the chamber is clear, push the rear takedown pin, pivot the upper receiver open, and slide the BCG out the back of the upper. Common mistake: forgetting to push the pin fully can cause the BCG to bind halfway out.
5. 5. Disassemble the Bolt for Cleaning: Press the bolt's retaining pin to remove the cam pin and firing pin, then slide the bolt out of the carrier. Use the EXTRACT-R's flat edge to gently pry carbon deposits from the bolt face and extractor hook. Common mistake: using a metal pick on the extractor spring can damage it; the tool's smooth edge is safer. Clean the extractor claw area first — it is the most common spot for carbon buildup that causes failures.
6. 6. Reassemble and Function-Check: Reinsert the bolt into the carrier, install the firing pin and cam pin, and rotate the cam pin into its locked position. Slide the BCG back into the upper, close the receiver, and push the takedown pin. Rack the charging handle to confirm smooth cycling. Common mistake: misaligning the cam pin can prevent the bolt from rotating, causing a dead trigger. After reassembly, dry-fire (with snap caps) to verify the hammer drops and resets correctly.

Product Facts

• EXTRACT-R™ AR-15 TOOL: The EXTRACT-R is a purpose-built, compact multi-tool designed to clear AR-15 and machine gun malfunctions quickly in the field. You can resolve stuck cases on the spot without needing a bench vise or specialized armorer tools, saving time and preventing range downtime.