How to Set Up the Leisure Carry Belt System for Concealed Carry

By Shop Tactical Gear & Holsters丨Guerrilla Tactical | Published: 2026-10-31

Category: How-to Guides

Learn how to set up the Leisure Carry Belt System for everyday concealed carry: position the clip-on belt, adjust fit, and mount an IWB holster securely.

Quick answer

Set up the Leisure Carry Belt System by clipping the belt directly onto your pants or shorts at your preferred carry height, adjusting the tension so it stays put without pinching, then mounting your IWB holster and testing the draw before you leave the house.

Why a clip-on belt system changes your carry setup

A traditional carry belt relies on belt loops and a rigid leather or nylon strap. The Leisure Carry Belt System takes a different approach: it clips onto the waistband of whatever you are wearing, which means you can carry with gym shorts, board shorts, or swimwear that have no belt loops. That flexibility is the main reason to consider this system, but it also means your setup depends on the waistband itself rather than a belt threaded through loops.

Because the belt is not anchored by loops, the clip placement and tension matter more than they would on a conventional belt. A loose clip or a waistband that rolls under load will let the whole system shift when you draw or holster. Treat the clip-on design as a system that needs to be fitted to the garment, not just clipped on and forgotten.

When the clip-on system makes sense, and when it does not

The Leisure Carry Belt System is a good fit for people who want to carry in light clothing, at the gym, or in casual settings where a dedicated gun belt would look out of place. It is also useful as a secondary setup for quick trips when you are not wearing your usual pants.

It is not a replacement for a stiff, loop-mounted belt when you carry a heavy full-size pistol all day. If your waistband is very thin or stretchy, the clip may not have enough material to grab securely, and you should test the setup thoroughly before relying on it. The V2 belt is offered in a TAN Topo pattern, which is a cosmetic choice; the fit and clip tension are what determine performance.

Step-by-step Leisure Carry Belt System setup

Choose the right garment and waistband: Put on the pants or shorts you plan to carry in. The waistband should be sturdy enough that it does not roll or stretch excessively when you clip the belt on. Thick elastic or reinforced waistbands work better than thin, loose fabric. If the waistband folds over easily between your fingers, the clip may not hold securely.
Position the belt at your carry height: Decide whether you want the belt to sit at your natural waist or lower on your hips, then clip it on so the holster mounting area aligns with where you want the gun to ride. For IWB carry, the belt should sit slightly below the waistband edge so the holster clip can grab both the belt and the pants. Check in a mirror that the belt is level; a tilted belt will make the holster cant inconsistent.
Adjust the clip tension: Most clip-on belts have a tension adjustment or rely on the clip's spring pressure. Set it tight enough that the belt does not slide when you pull upward on it, but loose enough that you can still remove it without damaging the garment. Test by tugging gently on the belt in several directions. A belt that shifts more than a finger's width under a firm pull is too loose for safe carry.
Mount your IWB holster: Attach your holster to the belt according to the holster manufacturer's instructions. If your holster uses clips, route them over both the belt and the waistband where possible. Make sure the holster sits at the cant and depth you want before tightening everything down. With the gun unloaded, holster it and check that the holster mouth stays open and accessible.
Test the draw and retention: With an unloaded firearm, practice a few slow draws and reholstering. The belt should stay in place and the holster should not shift. If the whole system moves, increase clip tension or switch to a thicker waistband. Any movement of the belt during the draw means the setup is not yet secure enough for everyday carry.
Do a final concealment check: Put on your cover garment and check from front, side, and back in a mirror. Bend, sit, and reach overhead to see if the grip or holster prints or if the belt shifts. Adjust the position slightly forward or back if needed. Recheck concealment after any change to your clothing or holster position.

Product facts

Leisure Carry Belt System - TAN Topo v2: Leisure Carry Belt System - TAN Topo v2 is a clip-on belt system designed for carry without a traditional belt, including gym shorts, board shorts, and swimsuits. This lets you set up a concealed carry platform on clothing that has no belt loops, but it also means you must check that the waistband can support the clip.
Leisure Carry Belt System - TAN Topo v2